WaterCop Z-Wave — Indoor/Outdoor Automatic Water Shut-Off System Specifications

Specification sheet for the WaterCop® Z-Wave automatic water shut-off system — combining trusted early electronic leak detection with Z-Wave smart home network integration, for indoor or outdoor installation.

Overview

WaterCop® Z-Wave combines the trusted benefits of early electronic leak detection and automatic water shut-off with the ability to operate on a Z-Wave enabled network, even outdoors. Once installed into a new or existing Z-Wave network, the WaterCop® Z-Wave control valve can be locally or remotely controlled via a gateway interface. It integrates with other automated home devices such as alarms and environmental controls for an added level of convenience and security.

• Puts homeowners in total control of their plumbing system — remotely set up a protocol for routine open/close of water systems (requires a properly integrated Z-Wave gateway controller and network access)
• Notifies key contacts the moment the system shuts off the main water supply
• Z-Wave wireless sensors placed at or near water-utilizing appliances monitor for plumbing leaks or sudden flooding
• Flood and temperature sensors transmit a closure signal through the Z-Wave network to the WaterCop® Z-Wave control valve on the main water supply

Features

Lead Free Valve

• Full flow, lead-free* brass ball valve (heavy duty industrial grade) for unsurpassed quality and performance
• Available in ½" – 1 ¼" sizes as standard (inquire for 1 ½" – 2" sizes)

Rugged Actuator

• When activated by a sensor, valve must be locally reset for maximum protection
• Electrically driven actuator for quick, reliable closure
• 110 VAC converted to 12 VDC (Class 2 power converter with 20' cord)
• Tested over 250,000 cycles for long product life

Flood Sensors

• Wireless and battery powered
• Sounds an audible alarm when leaks are detected
• Sounds an audible "chirp" when batteries are low

Indoor Z-Wave Ordering Information

Step One: Select the appropriate shut-off valve by size.

Step Two: Add ZWACT WaterCop® Z-Wave Actuator.
Step Three: Add ZWCFS100 Wireless Flood and Temperature Sensors.

Outdoor Z-Wave Ordering Information

Step One: Select the appropriate shut-off valve by size (same part numbers as above).

Step Two: Select the correct length outdoor Z-Wave kit.

Step Three: Add ZWCFS100 Wireless Flood and Temperature Sensors.

* Lead Free NSF/ANSI 372 refers to the wetted surface of pipe, fitting, and fixtures in potable water systems with a weighted average lead content ≤ 0.25%. Source: California Health & Safety Code (116875); Vermont Act 193. Made in the USA.

Manufacturer

WaterCop®
watercop.com · 800-545-3636