Skylink WM-201 — Keychain/Wallmount Transmitter Manual

User manual for the Skylink® WM-201 Keychain / Wallmount Transmitter — a remote that programs to a Skylink Swing Door Opener (model DM-001) for hands-free open/close/stop control, with an optional second door opener support.

What's Included

• Transmitter with 12V alkaline battery installed
• Mounting bracket
• Double-sided foam tape

Programming to the Swing Door Opener

1. The door opener should be in standby mode — adapter plugged in, red LED on steadily, door not operating.
2. Press and hold the "Learn" button on the door opener — red LED flashes and buzzer beeps, indicating learn mode.
3. While still holding the door opener's learn button, press and hold the button on the transmitter you want to program. You'll hear a long beep and the red LED will turn off.
4. Release both buttons — the door opener's red LED returns to steady on. The transmitter is now programmed.

You can program up to 15 single-button transmitters, or 7 Model WM-201 transmitters, to one swing door opener — useful for multiple household users each carrying their own remote.

Operation

Two operating modes are available (refer to your swing door opener's manual for mode details):

Toggle Mode

Pressing the programmed button toggles the door: open → close, or close → open. While operating, the orange LED flashes and the buzzer beeps. Pressing the button again mid-motion stops the door.

Open / Close Mode

The top button opens the door; the lower button closes it.

Installation as a Wall-Mount Button

Mount the transmitter on the wall near the door exit using the provided mounting bracket and double-sided foam tape. Ensure the wall surface is clean and smooth for good adhesion.

Additional Door Opener Support

If the swing door opener runs in toggle mode, the second button on the WM-201 can be programmed to operate a separate swing door opener — letting one remote control 2 doors.

Erasing All Programmed Transmitters

1. Unplug the door opener while in standby mode.
2. Press and hold the learn button, then plug the adapter back in while still holding the button.
3. The red LED flashes and the buzzer beeps rapidly — all transmitters are erased. Release the learn button.

Note: this erase operation removes all programmed transmitters at once; individual transmitters cannot be erased separately.

Battery

Uses a 12V alkaline battery (size 23A), included. Replace when the transmitter's red LED no longer lights when either button is pressed.

Troubleshooting

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to: (1) it may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation. Tested and found compliant with Class B digital device limits under Part 15, providing reasonable protection against interference in a residential installation. Changes or modifications not expressly approved by the responsible party could void the user's authority to operate the equipment.

Warranty

One-year limited warranty from date of purchase against defects in workmanship or materials (excluding battery) — repair or replacement without charge. Proof of purchase and a Return Authorization are required.

Customer Service

Skylink Group · 17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3 · support@skylinkhome.com · 1-800-304-1187 (Mon–Fri, 9am–5pm EST) · Fax (800) 286-1320 · www.skylinkhome.com