SECO-LARM ENFORCER EV-Y5105-N2SQ 4-in-1 HD Wall-Plate Camera — Manual

Manual for the SECO-LARM ENFORCER EV-Y5105-N2SQ 4-in-1 HD (TVI/CVI/AHD/Analog) Wall-Plate Camera — a weatherproof, vandal-resistant camera designed to mount to a standard single-gang or slimline wall plate.

Overview

The EV-Y5105-N2SQ features a 1/2.8" 2MP Sony STARVIS™ CMOS sensor with a 2.9mm wide-angle lens, supporting TVI (default), CVI, AHD, and Analog formats selectable via an external OSD joystick. It ships with a single-gang plate and a slimline plate, plus angled mounting rings for adjustable camera angle.

Features

• Switchable format: TVI, CVI, AHD, Analog
• 1/2.8" 2MP Sony STARVIS™ CMOS sensor
• 2.9mm wide-angle lens
• Weatherproof IP67 construction; vandal-resistant design
• Adjustable mounting angle (~20°)
• 2DNR (2D Digital Noise Reduction) and D-WDR (Digital Wide Dynamic Range)
• 12VDC operating voltage

Specifications

Parts List

1x Camera, 1x Single-gang plate, 1x Slimline plate, 1x Angled rubber ring, 1x Angled aluminum ring, 1x Aluminum hex nut, 1x OSD joystick, 2x Mounting screws, 1x Manual.

Before Starting

• Read the manual thoroughly and keep it for future reference.
• Use within given temperature and electrical limits; do not point at the sun.
• Avoid areas with radiation, strong magnetic/electrical fields, or extreme shock.
• Do not open or disassemble — no user-serviceable parts inside.

Installation

Mounting the Camera to the Plate

Position the angled rings behind the plate and twist the aluminum hex nut onto the camera to secure the plate. If a nearby object blocks the field of view, the angled rings can instead be installed in front of the wall plate to move the field of vision forward.

Changing the Mounting Angle

Install the angled rubber ring on the front of the plate to tilt the camera approximately 20°. Note: when installing, ensure the arrow label behind the lens points up.

Mounting Options

• Plate + back box (suggested): Mount the back box in the wall, then attach the plate and camera.
• Plate, no back box: Drill a 7/8" (22mm) hole in the wall for the camera body and mount the plate directly to the wall.
• No plate, no back box: Drill a 7/8" (22mm) hole. Min. wall thickness 5/16" (8mm), max. 15/16" (23mm). On thick surfaces, the angled rings may not be necessary.

Switching Between HD/Analog Outputs

Press the OSD joystick in the direction of the desired format and hold for 5 seconds; release when the camera restarts.

Troubleshooting

Important: Do not cut the video or power wires — this voids the warranty.

Warranty

Warranted against defects in material and workmanship for three (3) years from the date of sale. SECO-LARM U.S.A., Inc., 16842 Millikan Avenue, Irvine, CA 92606. Phone: (949) 261-2999 / (800) 662-0800.