Chamberlain CLLP1 / CLLP1-P — Laser Garage Parking Assist Owner's Manual

Owner's manual for the Chamberlain Laser Garage Parking Assist, Models CLLP1 and CLLP1-P — a laser guide that helps you park your vehicle in the same spot every time.

Safety Warnings

• Never point the laser at anyone.
• Never look directly into the laser beam.
• Never disassemble the laser.
• The parking assist is NOT a substitute for safe parking practices.
• Use of controls or adjustments, or performance of procedures other than specified, can result in hazardous radiation exposure.
• For use ONLY on Chamberlain-manufactured garage door openers.
• Class II laser product. Maximum power output: < 1mW @ 635-670nm.
• California Prop 65 Warning: This product can expose you to chemicals including lead, known to the State of California to cause cancer or birth defects/reproductive harm. See www.P65Warnings.ca.gov.

Installation

1. Open your garage door and park your vehicle outside of the garage.
2. Determine the mounting location on the ceiling and fasten the parking assist using the included screw and anchor.
3. Depress the tabs under the wires and temporarily remove the white and white/black safety sensor wires from the garage door opener.
4. Strip the wires:
   • Installing one parking assist: Separate the white and white/black wires and strip 7/16" (11mm) of insulation from the parking assist wires.
   • Installing two parking assists: Cut 6" (15cm) of wire from the end of one set of parking assist wires for use as connection wires. Separate white and white/black wires and strip 7/16" (11mm) of insulation from both ends of the connection wire.
5. Connect the wires to the garage door opener:
   • Installing one parking assist: Twist like-colored wires (parking assist and safety sensors) together. Insert twisted wires into the quick-connect holes: white to white, white/black to grey.
   • Installing two parking assists: Twist like-colored wires for parking assists, safety sensors, and connection wire together, secure with a wire nut, then insert connection wires into the quick-connect holes: white to white, white/black to grey.
6. Refer to your garage door opener's owner's manual for proper wire installation specifics.

Set Up and Adjustment

1. Drive your vehicle into the garage and park in the desired location.
2. Activate the parking assist by obstructing the path of the safety sensors. The laser emits a pulsing bright red beam — aim it at a location on the dash or hood that's easily visible from the driver's seat.
3. Sit in the driver's seat and confirm you can easily see the beam location. This becomes your reference point for parking. Caution: do not stare directly into the beam. Repeat for an optional 2nd laser accessory kit.

Note: The laser shuts off after 1 minute. If not finished adjusting, simply obstruct the safety sensors again to reactivate. Periodic re-adjustment of the beam may be required.

Operation

1. Open the garage door and drive your vehicle into the parking space.
2. The red beam moves across the hood of your vehicle as you drive further into the garage.
3. Stop the vehicle when the beam reaches the reference location confirmed during setup.

Note: The laser activates every time you drive into the garage and shuts off after about 1 minute. A residual reflection of the beam may appear on walls/objects. Always ensure no objects are on the garage floor or in the vehicle's path. The parking assist is not a substitute for safe parking practices.

Troubleshooting

If the laser does not emit a beam:

• Verify nothing is obstructing the safety sensors.
• Verify nothing is blocking the parking assist lens.
• Verify connections are not reversed.
• Verify all connections are secure.
• Confirm the parking assist is aimed toward the garage floor.
• Obstruct the path of the safety sensors and look for the red spot on the garage floor.

Refer to your garage door opener owner's manual for additional information on the opener and safety sensors.

Support

chamberlain.com • 1-800-528-9131