2GIG-KEY2-345 4-Button Key Ring Remote — Install Instructions

Install instructions for the 2GIG-KEY2-345 4-Button Key Ring Remote, a wireless key fob for the 2GIG security system control panel.

Overview

The 2GIG-KEY2-345 is a 4-button key ring remote that enables you to turn the 2GIG system on and off before entering or after exiting the home. In an emergency, it can turn on the siren and automatically call the central monitoring station. If lamp modules are installed, the fob can turn all system-controlled lights on or off via the open collector output. It also works with the 2GIG-GDR1-345 to open a garage door. The fob is powered by a lithium coin battery and fits on a keychain, in a pocket, or a purse.

Functions

• Arm the system (doors, windows, and motion sensors)
• Arm the system with no entry delay (if programmed)
• Disarm the system
• Trigger panic alarms
• Turn system-controlled lights on or off (via the open collector output)
• Other open collector output functions (if applicable)
• Open a garage door when used with the 2GIG-GDR1-345

Box Contents

• Key fob
• Key ring
• Lithium battery (included)

Programming the Fob into the 2GIG Control Panel

Scroll between options using the ← and → arrows. Move to the previous or next prompt with the ↑ and ↓ arrows.

1. Go to Q3: Select fob # (1 to 8).
2. Select fob used/enabled (0 = unused/disabled, 1 = used/enabled).
3. Select RF sensor equipment code. Enter 0866 for the 2GIG-KEY2-345 4-Button Key Ring Remote.
4. Enter RF sensor serial number (7 digits) — manually type the last 7 digits of the TX ID found outside the box or on the back of the device, or use Auto Entry: put the panel in Learn-in mode (press Shift then Learn) and accept the TX ID that appears by pressing OK. Press ↓ to continue through the configuration prompts.
5. Select RF sensor equipment age: (0) new or (1) existing.
6. Select fob emergency key: (0) disabled, (1) auxiliary alarm, (2) audible alarm, (3) silent panic, (4) fire.
7. Select fob key 2 can disarm: (0) disabled, (1) enabled.
8. Construct RF sensor voice descriptor: press Insert then a number 002–255 to add a word (e.g., 138=MAIN, 121=KEY, 183=Remote to name it "main key remote").
9. Select fob arm no delay: (0) disabled, (1) enabled.
10. Select fob key 4 output: (0) disabled, (1) toggle output, (2) momentary output.
11. Click Next to program another sensor, or click Skip then End and Exit to finish (the panel reboots on exit).

Tip: Each key fob learned in uses one of the available fob sensor numbers as programmed in step 1.

Programming Key Fobs into the 2GIG-GDR1-345 (Garage Door Receiver)

1. Press and release the learn button (the learn indicator lights if there is room in memory).
2. Activate the Auxiliary button on the key fob while the indicator is lit (within 15 seconds). The receiver's indicator flashes. Repeat for additional key fobs (up to 10).

Testing

1. From the Installer Toolbox, select Walk Test.
2. Disarm button: hold for 2 seconds to disarm the panel and all doors/windows/motion detectors.
3. Away button: hold for 2 seconds to arm the panel and doors/windows in Away mode.
4. Stay button: hold for 2 seconds to arm the panel and doors/windows in Stay mode.
5. Auxiliary button (if programmed): triggers a pre-selected output.
6. Emergency key: press Away and Disarm together for 5 seconds to send a silent panic, audible alarm, silent panic, or fire signal (depending on what was programmed in step 6 of programming).
7. Exit the Installer Toolbox.

Batteries

WARNING: Observe correct battery polarity. Improper handling of lithium batteries may cause heat generation, explosion, or fire, resulting in injury. Replace only with the same or equivalent battery type. Do not recharge, disassemble, or dispose of in fire. Dispose of used batteries per local waste/recycling regulations. Keep away from small children — if swallowed, seek medical attention promptly.

California only: Perchlorate warning applies to Manganese Dioxide Lithium cells sold/distributed in California; see dtsc.ca.gov/hazardouswaste/perchlorate.

Specifications

Regulatory & Warranty

Complies with FCC Part 15 Class B and Industry Canada regulations (FCC ID: WDQ-KEY2345; Industry Canada ID: 7794A-KEY2345). Warranted against defects in material and workmanship for 2 years, extending only to wholesale customers buying direct from 2GIG Technologies or through its normal distribution channels. Support: 855-2GIG-TECH (855-244-4832).