Leviton W5601 — Weather-Resistant Single Pole Switch Installation Instructions

Installation instructions for the Leviton Weather Resistant Single Pole Switch (Cat. No. W5601), rated 15A-120/277V AC, for use in a standard single-gang FS or FD weatherproof box.

Product Description

The W5601 is a self-contained weather-resistant single pole switch designed for a standard, single-gang FS or FD weatherproof box.

Installation Notes

• Install over smooth, flat surfaces (metal or vinyl siding, clapboard, or plywood). If the mounting surface is not smooth, use silicone sealant to ensure a proper seal.
• Mount the device in a single-gang wallbox only.
• Use only the six provided mounting screws.
• For a standard single-gang wallbox, mount in the two center screw locations with two of the provided screws, tightened to 14-16 in-lb of torque.
• For an FS or FD weatherproof box, mount using all six provided screws in the two center screw locations plus four additional screw locations, tightened to 14-16 in-lb of torque.
• Use a punch or 9/64 in. drill bit to remove extra material at the four additional screw-mount locations.

Installation Steps

1. Remove wallplate: insert a flat-head screwdriver into the notch at the bottom of the wallplate to remove it.
2. Identify your wires: Line, Load, Neutral, and Ground, typically connected From/To Branch Circuit and To Load.
3. Wire: work on one connection at a time, connecting wires per the diagram.
   • Back wire: remove insulation per the strip gauge on the device (approx. 5/8 in. / 1.6 cm). Insert straight wires under clamps of the appropriate terminal screws. Tighten with 14-18 in-lb of torque. Back wire terminal screws accept up to #10-14 AWG copper or copper-clad wire.
   • Side wire: remove insulation to approx. 5/8 in. (1.6 cm) per the strip gauge. Loop wires clockwise 3/4 around terminal screws. Tighten with 14-18 in-lb of torque. Side wire terminal screws accept up to #12-14 AWG copper or copper-clad wire.
4. Mount the device.
5. Tighten mounting screws to 14-16 in-lb of torque to ensure a proper seal. Seal between the gasket and mounting surface, and between all mounting screws and their individual gaskets.
6. Install wallplate, making sure the notch is on the bottom.
7. Restore power at the circuit breaker or fuse. Installation is complete.

Ratings

• 15A-120/277V AC

Warnings and Cautions

• To avoid fire, shock, or death: turn off power at the circuit breaker or fuse and test that power is off before wiring.
• To be installed and used in accordance with electrical codes and regulations. If unsure about any part of these instructions, consult an electrician.
• To avoid damage to the product, do NOT use disinfecting products, foggers, sprays, or other atomized cleaning agents. Do NOT spray liquid onto the product — use a damp cloth with mild soap to clean.
• Use this device with copper or copper-clad wire only.

Warranty

Limited 2 Year Warranty and Exclusions. Void if installed improperly, in an improper environment, overloaded, misused, opened, abused, or altered. For details visit leviton.com or call 1-800-824-3005 (USA) / 1-800-405-5320 (Canada).

Manufacturer: Leviton Manufacturing Co., Inc., 201 North Service Road, Melville, NY 11747 · 1-800-824-3005 · leviton.com