Ecolink WST-201 — Wireless Contact (Door/Window Sensor)

Installation and reference manual for the Ecolink WST-201 Wireless Contact — a 319.5MHz door/window sensor compatible with GE/Interlogix security receivers.

Specifications

Enrolling

Put your alarm panel into program mode and go to the Learn Sensors menu (refer to your specific panel's manual for the exact menu path). To activate the case tamper, slide the cover up and down — you'll hear a click as the case latches engage and disengage. Continue until the panel responds, then select the appropriate sensor group and number.

Mounting

• Double-sided tape is included for both the contact and the magnet. Ensure the mounting surface is clean and dry, apply the tape, then press firmly for several seconds.
• Avoid mounting the tape at temperatures below 50°F — though the bond will hold at low temperatures after a 24-hour cure.
• One side of the sensor is marked with 3 lines, indicating the location of the reed switch. Mount the magnet facing this side, no further than 5/8" from the sensor.

Interchangeable Covers

The contact ships assembled with a white cover; brown covers are included as an option. To swap covers, slide the front cover to disengage it from the sensor, then remove it. When installing the replacement, make sure the "Top" marking on the inside of the cover points away from the battery — you should hear a click when it engages. The back plastic does not need to be swapped since it's hidden once mounted. To swap the magnet cover, gently pry the white cover off with a flat-head screwdriver and snap the brown cover into place.

Replacing the Battery

A low-battery signal is sent to the control panel when the battery needs replacing.

1. Slide the top cover to disengage it from the sensor, then remove it to reveal the battery.
2. Replace with a CR2032 battery, ensuring the + side faces towards you.
3. Reattach the cover with the "Top" marking pointing away from the battery — you should hear it click into place.

Note: Removing the cover triggers a zone tamper signal to the control panel.

Compliance

This equipment complies with FCC Part 15 Class B digital device limits, designed to provide reasonable protection against harmful interference in residential installations. If interference to radio or TV reception occurs, try reorienting/relocating the receiving antenna, increasing separation between the equipment and receiver, connecting the equipment to an outlet on a different circuit, or consulting a dealer/experienced radio-TV technician. Changes or modifications not expressly approved by Ecolink Intelligent Technology Inc. could void the user's authority to operate the equipment.

This device complies with Industry Canada licence-exempt RSS standard(s); operation is subject to the condition that the device must accept any interference received, including interference that may cause undesired operation.

FCC ID: XQC-WST201  |  IC: 9863B-WST201

Warranty

Ecolink Intelligent Technology Inc. warrants this product free from defects in materials and workmanship for 5 years from the date of purchase. This warranty does not cover damage from shipping/handling, accident, abuse, misuse, misapplication, ordinary wear, improper maintenance, failure to follow instructions, or unauthorized modification. Ecolink will, at its option, repair or replace defective equipment returned to the original point of purchase. Maximum liability under all circumstances is limited to replacement of the defective product. Customers should check equipment regularly for proper operation.

Ecolink Intelligent Technology Inc., 2055 Corte Del Nogal, Carlsbad, CA 92011 · 1-855-632-6546 · www.discoverecolink.com · PN WST201 R1.01