DataComm Electronics 45-0016 — Décor Insert with Flexible Opening Installation Sheet

Installation instructions for the DataComm Electronics 45-0016 Décor Insert with Flexible Opening — used to route low-voltage cables behind a wall-mounted HDTV, amplifier, or other AV device. Mounts onto a low-voltage mounting bracket (sold separately) that is installed into the wall.

Important Notes

• Designed for low-voltage cable use only.
• Do not run or pull a TV cord or other electrical cords inside the wall — running power/extension cords behind the wall violates the National Electric Code (NEC).

Tools Needed

Phillips head screwdriver.

Installation Steps

1. Before installing the Décor Insert, first install a low-voltage mounting bracket (sold separately) into the wall, per the bracket's own instructions.
2. Run up to four (4) low-voltage A/V cables through the opening in the low-voltage mounting bracket, then through the opening of the Décor Insert.
3. Place the Décor Insert against the low-voltage mounting bracket and secure it in place with the two (2) included screws.
4. For a finished look, install a décor wall plate (sold separately) over the Décor Insert.

Safety Warnings

• Never install low-voltage wiring during lightning storms.
• Never touch un-insulated wires or terminals unless disconnected at the network interface.
• Use caution when installing or modifying data or telecommunication lines.
• Do not alter, change, or disconnect existing telecommunication wires if you are unsure of their purpose or function.
• Not recommended for installation in close proximity to an electrical service panel, to avoid interference from electrical current.

Important Instructions

• Read and understand all instructions.
• Do not use this product near water — bath tub, wash bowl, kitchen sink, laundry tub, wet basement, or swimming pool.
• Save these instructions.

This product is patent protected by U.S. Patent number 7495171. RoHS Compliant.