Autoslide AS058PML Pet Mat — Setup Instructions

Setup instructions for the Autoslide AS058PML Pet Mat — a wireless pressure-sensitive trigger mat used with Autoslide automatic pet doors to let pets open the door by stepping on the mat.

Installation

1. Your AutoSlide unit should already be installed and programmed. Remove the cover of your AutoSlide unit.
2. Plug the Pet Mat's cable into the Wireless Transmitter. Be sure to remove the plastic tab from the Wireless Transmitter before using.
3. Press Sensor Learn on your AutoSlide control panel — the red light by this button will light up and stay lit.
4. Step on the Pet Mat to trigger it. If done correctly, a blue light will flash on the Wireless Transmitter.
5. Repeat steps 3 and 4 (press Sensor Learn again, then trigger the Pet Mat again).
6. Wait a few moments, then confirm the Pet Mat is paired to your unit by triggering it to open the door.

Tip: A video of this process and how to change the transmitter's batteries can be found on the Autoslide USA Tech Help YouTube channel.

Protection Advice

• Pet Mats should always be placed underneath or inside a protective covering such as a rug, doormat, or carpet.
• When placed outdoors or in extreme temperatures/humidity, protect the Wireless Transmitter from the elements with a shield or casing.
• The point where the Pet Mat cable enters/attaches to the mat is already well insulated, but keep this portion away from humidity, elemental wear, or risk of physical damage.
• For extra protection on an outdoor mat, tape the edges of the mat to the ground.

Sensor Mode Notes

There is a switch on the motherboard of the Wireless Transmitter to control which sensor on the unit the pet mat triggers:

• Pet: Makes the pet mat trigger the Pet Sensor on the unit — only works when the unit is in Pet Mode (if Pet Mode has already been programmed).
• Slave: Makes the pet mat trigger the Outside Sensor on the unit — enabled only in Green and Pet Mode.
• Master: Makes the pet mat trigger the Inside Sensor on the unit — enabled in Green, Red, and Pet Mode.

Each Pet Mat transmitter takes four CR2016 batteries.

Troubleshooting

• If your Pet Mat is not responsive but the blue light on the Wireless Transmitter is flashing, make sure the unit is in the correct mode for the switch the Wireless Transmitter is set to (see Sensor Mode Notes above).
• If your Pet Mat is still not responsive and the sensor is set to work in the unit's current mode, try changing the batteries in the Wireless Transmitter. If this doesn't resolve the issue, attempt to relearn the Pet Mat to the unit by following the Installation instructions again.

Support

Autoslide LLC — autoslide.com — 833-337-5433