Uniview Network Mini Dome Cameras — Quick Start Guide

Quick start guide covering installation safety, disclaimers, and regulatory compliance for Uniview network mini dome / bullet camera models.

About This Guide

This guide applies to multiple Uniview network camera models; photos, illustrations, and descriptions may differ slightly from the actual appearance, functions, or features of your specific product. The device must be installed, serviced, and maintained by a trained professional with the necessary safety knowledge and skills.

Safety Warnings

Storage, Transportation & Use

• Store or use the device in a proper environment meeting requirements for temperature, humidity, dust, corrosive gases, and electromagnetic radiation.
• Make sure the device is securely installed or placed on a flat surface to prevent falling.
• Unless otherwise specified, do not stack devices.
• Ensure good ventilation; do not cover the vents on the device.
• Protect the device from liquid of any kind.
• Make sure the power supply provides a stable voltage that meets the device's power requirements, and that the supply's output exceeds the total maximum power of all connected devices.
• Verify the device is properly installed before connecting it to power.
• Do not remove the seal from the device body without consulting Uniview first; do not attempt to service the product yourself — contact a trained professional.
• Always disconnect the device from power before moving it.
• Take proper waterproof measures before using the device outdoors.

Power Requirements

• Install and use the device in strict accordance with local electrical safety regulations.
• Use a UL certified power supply that meets LPS requirements if an adapter is used.
• Use the recommended cordset (power cord) in accordance with specified ratings.
• Only use the power adapter supplied with your device.
• Use a mains socket outlet with a protective earthing (grounding) connection, and ground the device properly if it is intended to be grounded.

Battery Use Caution

• Avoid extremely high or low temperature and air pressure during use, storage, and transportation.
• Avoid battery replacement outside of authorized service.
• Improper use — replacing with an incorrect type, disposing in fire or a hot oven, or mechanically crushing/cutting the battery — can cause fire, explosion, or leakage of flammable liquid or gas.
• Dispose of used batteries according to local regulations or the battery manufacturer's instructions.

Regulatory Compliance

• LVD/EMC Directive: Complies with EU Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU.
• WEEE Directive 2012/19/EU: Covered by the Waste Electrical & Electronic Equipment Directive; must be disposed of responsibly.
• Battery Regulation (EU) 2023/1542: For proper recycling, return the battery to your supplier or a designated collection point.
• EU Authorised Representative: UNV Technology EUROPE B.V., Room 2945, 3rd Floor, Randstad 21-05 G, 1314 BD, Almere, Netherlands.
• FCC Statement: Complies with Part 15 of the FCC Rules. Operation is subject to the condition that the device must accept any interference received. Tested and found to comply with Class A digital device limits per Part 15 of the FCC Rules — designed for reasonable protection against harmful interference in a commercial environment. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Manufacturer

Zhejiang Uniview Technologies Co., Ltd. · www.uniview.com · ©2020-2024 Zhejiang Uniview Technologies Co., Ltd. All rights reserved.