Uniview Analog Bullet Camera — Quick Start & Safety Guide

Overview

This is the general Quick Start / Safety Guide covering Uniview's Analog Bullet Camera product family. It provides the required safety warnings, installation guidelines, and regulatory compliance information applicable to Uniview analog bullet cameras before installation and use.

Safety Warnings

The device must be installed, serviced, and maintained by a trained professional with the necessary safety knowledge and skills. Read through this guide carefully and make sure all applicable requirements are met to avoid danger and loss of property.

Storage, Transportation & Use

• Store or use the device in a proper environment meeting requirements for temperature, humidity, dust, corrosive gases, and electromagnetic radiation
• Ensure the device is securely installed or placed on a flat surface to prevent falling
• Unless otherwise specified, do not stack devices
• Ensure good ventilation; do not cover vents on the device
• Protect the device from liquid of any kind
• Verify the power supply provides stable voltage meeting the device's requirements, and that the power supply's output exceeds the total maximum power of all connected devices
• Verify the device is properly installed before connecting to power
• Do not remove the seal from the device body without consulting Uniview first; do not attempt to service the product yourself — contact a trained professional
• Always disconnect the device from power before moving it
• Take proper waterproofing measures before using the device outdoors

Power Requirements

• Install and use the device in strict accordance with local electrical safety regulations
• Use a UL-certified power supply that meets LPS requirements if an adapter is used
• Use the recommended cordset (power cord) per specified ratings
• Only use the power adapter supplied with your device
• Use a mains socket outlet with a protective earthing (grounding) connection, and ground your device properly if intended to be grounded

Battery Use Caution

When the battery is used, avoid extremely high or low temperature/air pressure during use, storage, and transportation, and avoid battery replacement outside of manufacturer guidance. Improper use — replacing with an incorrect battery type, disposing of a battery in fire or a hot oven, or mechanically crushing/cutting a battery — may cause fire, explosion, or leakage of flammable liquid or gas. Dispose of used batteries according to local regulations or the battery manufacturer's instructions.

Regulatory Compliance

• LVD/EMC Directive: Complies with European Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU
• WEEE Directive 2012/19/EU: Covered by the Waste Electrical & Electronic Equipment Directive; must be disposed of responsibly
• Battery Regulation (EU) 2023/1542: Battery in the product complies with the European Battery Regulation; return to your supplier or a designated collection point for proper recycling
• FCC Statements: Complies with Part 15 of the FCC Rules — operation is subject to (1) not causing harmful interference and (2) accepting any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with Class A digital device limits per Part 15 of the FCC Rules, providing reasonable protection against harmful interference in a commercial environment. Operation in a residential area is likely to cause harmful interference, in which case the user must correct the interference at their own expense.

EU Authorised Representative

UNV Technology EUROPE B.V.
Room 2945, 3rd Floor, Randstad 21-05 G, 1314 BD, Almere, Netherlands

Note: This manual covers multiple analog bullet camera models; photos, illustrations, and descriptions may differ from the actual appearance and features of a specific model. Refer to your specific model's datasheet for detailed specifications.