Skylink R3-T4 — 4-Button Keychain Remote Instruction Manual

Instruction manual for the Skylink R3-T4 4-button keychain remote control, compatible with Skylink R3 series gate/garage door receivers.

Introduction

The Skylink R3T4 keychain remote allows you to operate up to 4 different Skylink R3 series receivers. The package includes a keychain remote control with a 12V alkaline battery already installed.

Programming

In order for this remote to operate your receiver, you must "learn" it to your receiver. Follow the instructions for your specific receiver model:

For R3G Receiver (add remote to auto-assigned location)

1. Press ADD — the display shows 0 0 0, the default memory location.
2. Press ADD again to select the memory location.
3. Press the button on the remote you would like to use to operate the receiver.
4. The receiver emits 3 beeps and the remote is confirmed programmed. The display then shows the next available memory location.
5. Press DISP twice to exit, or add another remote by pressing its button.

For R3R Receiver (learn remote control)

1. Press and hold the Learn button — the red LED flashes.
2. Activate the remote control by pressing the button you would like to use to operate the receiver. The red LED on the R3R stops flashing and remains on when the remote is programmed. This confirms the remote is programmed to the receiver.

Operation

Pressing the learned button will activate the programmed receiver.

Battery Replacement

Uses one 12-volt alkaline battery, Type 23A (included). It is time to change the battery when the red LED on the transmitter does not turn on when either button is pressed, or the operating range starts to decrease.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, designed to provide reasonable protection against harmful interference in a residential installation. If this equipment causes harmful interference to radio or television reception, try: reorienting or relocating the receiving antenna; increasing the separation between the equipment and receiver; connecting the equipment into an outlet on a different circuit; or consulting the dealer or an experienced radio/TV technician.

Warranty

If, within one year from date of purchase, this product becomes defective (except battery) due to faulty workmanship or materials, it will be repaired or replaced without charge. Proof of purchase and a Return Authorization are required.

Customer Service

Skylink Group — 17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email: support@skylinkhome.com
Web: www.skylinkhome.com
Toll free: 1-800-304-1187 (Mon–Fri, 9am–5pm EST)   Fax: (800) 286-1320