SECO-LARM ENFORCER MVE-AHMPM-41NQ 4K HDMI Extender over IP — Manual

Complete manual for the SECO-LARM ENFORCER MVE-AHMPM-41NQ 4K HDMI Extender over IP — extends HDMI video/audio and IR control signals over a single Cat5e/6 cable in One-to-One or One-to-Many configurations.

Overview

The MVE-AHMPM-41NQ extends the range of HDMI signals using an active transmitter and receiver to send video and audio over a single Cat5e/6 cable. It supports IR signals via the included IR transmitter and receiver, allowing remote control use from one end of an installation to control a device such as a media player or DVD player at the opposite end. Supports One-to-One and One-to-Many installations, allowing multiple units to be connected for extended range.

Features

• Extends HDMI over one Cat5e/6 cable or IP network
• Supports One-to-One and One-to-Many applications
• Power adapters and IR hardware included
• IR support (20kHz~60kHz)
• HDCP compliant
• Receiver (MVE-AHMPM-41NRQ) also available separately

Parts List

• 1x Transmitter
• 1x Receiver
• 1x IR Transmitter
• 1x IR Receiver
• 2x Power adapters
• 1x Manual

Specifications

*Input/output ports are reversed on the transmitter vs. the receiver.

Installation

1. Determine the location where the units will be installed and how much Cat5e/6 cable will be necessary.
2. Connect the transmitter to the HDMI output of the source device.
3. Connect the transmitter and receiver:
   • One-to-One: connect one end of the Cat5e/6 cable to the transmitter and the other end directly to the receiver.
   • Switch/router: connect one end of the Cat5e/6 cable to the transmitter and the other end to a switch or router, then connect the receiver to the other end of the switch/router with a second cable.
4. Connect the receiver to the HDMI input of the display or other device.
5. Connect one 5VDC power adapter to the transmitter and the other to the receiver.
6. For remote control support: install the IR transmitter extension to the IR OUT port of the transmitter (pointed at the device's IR sensor), and the IR receiver extension to the IR IN port of the receiver (in line of sight of the remote).
7. Switch on the HDMI source and display to verify the system is functioning — it may take up to a minute to sync the video stream.

Sample Applications

One-to-One: HDMI source → Transmitter → Cat5e/6 cable (up to max range per Specifications above) → Receiver → HDMI Display. IR transmitter/receiver extensions allow remote control at either end.

One-to-Many (Switch/Router): Multiple transmitter/receiver pairs can share a LAN switch — one HDMI source feeding several displays, each with independent IR remote control at the display end.

Warranty & Compliance

• One (1) year limited warranty against defects in material and workmanship under normal service.
• California Proposition 65 Warning: product may contain chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
• HDMI, the HDMI Logo, and High-Definition Multimedia Interface are trademarks of HDMI Licensing LLC.

Copyright © 2021 SECO-LARM U.S.A., Inc. Specifications subject to change without notice.