On-Q/Legrand One Bay Module Mounting Bracket (364890-01/AC1007) — Installation Instructions

Installation sheet for the On-Q/Legrand One Bay Module Mounting Bracket (P/N 364890-01) and One Bay Horizontal Module Mounting Bracket (P/N AC1007). Both brackets mount bay-style modules inside an On-Q style structured wiring enclosure.

Overview

The One Bay Module Mounting Bracket and the One Bay Horizontal Module Mounting Bracket are designed with two tabs on the left side and a push-pin on the right side for mounting inside an On-Q enclosure. Each bracket has four holes used to secure a module to the bracket via the plungers located at each corner of the module. The Horizontal version is designed specifically to allow coaxial cable to run from the top of the enclosure to the bracket without a sharp bend radius.

Installation Steps

1. Pull out the plungers located at each corner of the module.
2. Insert the module into the bracket, then depress the plungers to secure the module to the bracket.
3. Insert the bracket's left-side tabs into the slots on the left-hand side of the On-Q enclosure.
4. Secure the bracket in place using the push-pin on the right end of the bracket.

Specifications

• One Bay Module Mounting Bracket — P/N 364890-01
• One Bay Horizontal Module Mounting Bracket — P/N AC1007
• Manufacturer: On-Q/Legrand
• Document: IS-0350 Rev. O

©Copyright 2006 by On-Q/Legrand. All Rights Reserved.