Leviton Extender Bracket (47612-42B / 47612-28B) — Installation Instructions

Installation instructions for the Leviton Extender Bracket (Cat. No. 47612-42B and 47612-28B) — a mounting bracket used to add end rails, side rails, and an "L" bracket to Leviton Structured Media Center enclosures.

Important Safety Information

Hazard of electric shock. Not intended for installation on powered wire or circuits. Extreme caution should be exercised to avoid physical contact with bare conductors or terminals, as ringing voltage could be in excess of 100 volts AC. Never attempt repair, installation, or modification of low voltage equipment or wiring systems if you wear an electronic heart regulation device. If you are unfamiliar with low voltage wiring, consult a qualified technician.

• Read and understand all instructions. Follow all warnings and instructions marked on the product.
• Do not use this product near water — e.g., near a tub, wash basin, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
• Never push objects of any kind into this product through openings, as they may touch dangerous voltages.
• Save these instructions.

Additional Safety Information

• Never install communications wiring or components during a lightning storm.
• Never install communications components in wet locations unless the components are designed specifically for use in wet locations.
• Never touch uninsulated wires or terminals unless the wiring has been disconnected at the network interface.
• Use caution when installing or modifying communications wiring or components.

Components

• Structured Media Center
• End Rails
• Side Rails
• "L" Bracket (2 places)
• Cover
• Screws (12 places for bracket assembly; 6 places for Cat. No. 47612-42B mounting, or 4 places for Cat. No. 47612-28B mounting)

Assembly Steps

1. Step 1: Position the End Rails and Side Rails against the Structured Media Center frame.
2. Step 2: Attach the "L" Bracket at the two designated locations using the provided screws (12 places).
3. Step 3: Secure the assembled bracket to the Structured Media Center enclosure using the mounting screws — 6 screws for the 47612-42B version, or 4 screws for the 47612-28B version.
4. Step 4: Install the Cover over the completed assembly.

Note: All illustrations in the original instruction sheet depict the Cat. No. 47612-42B version; the 47612-28B version follows the same steps with fewer mounting screws.

Ordering Information

Technical assistance: 1-800-824-3005 (U.S.A. only), or fax 1-800-824-9538. Canada: 1-800-405-5320, fax 1-800-563-1853. www.leviton.com/lin