Enbrighten 59338 Z-Wave Plus In-Wall Smart Toggle Switch — Product Specifications

Product specifications for the Enbrighten Z-Wave Plus In-Wall Smart Switch, Toggle (Model 59338) — a 700-series Z-Wave Plus switch with S2 security and SmartStart support.

Specifications

Design Features

• QuickFit — reduces housing depth by up to 20% vs. previous models and eliminates the need for heat tabs.
• SimpleWire — patented auto-sensing line/load terminals detect line and load wires and configure the switch automatically; dual ground ports support daisy-chaining in multi-switch setups.
• New blue LED backlit toggle with four adjustable brightness settings; LED status can be inverted (always OFF / always ON).
• Manual ON/OFF control or via Z-Wave hub/controller; remote monitoring via mobile device with a compatible hub.
• Voice control via Amazon Alexa or Google Home (requires compatible hub).
• Supports single-pole installation, or 3-, 4-, 5-, or 6-way wiring with up to four Enbrighten add-on switches (traveler wire required for multi-pole).
• Works with LED, CFL, incandescent, and halogen bulbs.
• Can be included in multiple groups and scenes; supports Z-Wave firmware updates over the air.
• Screw terminal installation for line (hot), load, neutral, and ground; uses a standard toggle wallplate (sold separately).
• In-line traveler circuit protection. Z-Wave Plus certified.

Z-Wave Plus with S2 Security & SmartStart

• QR codes provide unique, industry-standard secure key exchange with 128-bit encryption.
• Effortless pairing to Z-Wave S2 and SmartStart certified gateways.
• Backward compatible with all generations of Z-Wave devices.
• 250% faster processor, 400% more memory, 50% more energy efficient than prior generation.
• Improved battery life and up to 50% greater wireless range for battery-powered companion devices.

Installation Recommendations

• Insert wire into the terminal port and tighten the screw — do not wrap the wire around the screw.
• Indoor use only.
• Wallplates are sold separately.
• Trilingual instruction manual included (English, French, Spanish).

Device Configuration

Adding to a Z-Wave Network

1. Follow your Z-Wave certified controller's instructions to add a device to the network.
2. Once the controller is ready to add the device, push the toggle up or down.

Once added, you get full ON/OFF control via groups, scenes, schedules, and automations programmed by your controller. If your controller supports remote access, you can control the switch from a mobile device. If prompted for the S2 security code, refer to the QR code / security number on the box or product label and enter the 5-digit code.

Removing and Resetting the Device

1. Follow your Z-Wave certified controller's instructions to remove the device from the network.
2. Once the controller is ready to remove the device, push the toggle up or down.

Returning to Factory Defaults

1. Slide the air gap switch to the right.
2. While pressing the OFF (bottom) button, push the air gap left and continue pressing OFF. The LED will flash through eight colors once.

Note: This should only be used if the network's primary controller is missing or inoperable.

SmartStart: SmartStart-enabled products can be added to a Z-Wave network by scanning the QR code on the product with a controller that supports SmartStart inclusion — no further action is required, and the product will be added automatically within 10 minutes of being switched on within network range.

Related Products (Enbrighten Z-Wave In-Wall Smart Controls)

• 58436 — In-Wall Smart Switch
• 59341 — In-Wall Smart Dimmer
• 58449 — In-Wall Smart Outlet

Manufacturer Support

Distributed by Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114. U.S.-based Consumer Care: 1-800-654-8483, M–F, 7AM–8PM Central Time.