ELK-AEZW — Z-Wave Module for E27 Installation Instructions

Installation and configuration instructions for the ELK-AEZW — a Z-Wave Interface Module for the E27 Alarm Engine that lets the E27 control Z-Wave lights, locks, thermostats, garage doors, and window covers.

Application

The AEZW connects to the E27 through a dedicated Z-Wave connector via a ribbon cable, adding a full Z-Wave Plus (500 Series) network to the Alarm Engine system.

Specifications

Installation Instructions

IMPORTANT: Before installing the Z-Wave Module, turn the E27 master power switch OFF.

1. Locate the ZWAVE connector on the right side of the E27 board.
2. Plug the keyed connector from the AEZW ribbon cable into the ZWAVE connector on the E27 board — the notch on the connector should face outward.
3. Power up the E27 board with the master power switch. The LED on the AEZW will be Red for several seconds after power-up before turning Green.

LED Status

Configuration (via ElkConnect App)

The ElkConnect app must be installed on the mobile device used to configure the E27 Alarm Engine.

1. Launch the ElkConnect app and connect to the E27 Alarm Engine.
2. From the main menu, navigate to the System Settings page. Tap the toggle beside "Use Z-Wave" to enable, then tap SAVE.
3. The main menu now displays a new "Automations" section. Tap Automations, then tap Z-Wave Devices to view all included Z-Wave devices.

Including New Z-Wave Devices

Before starting inclusion, familiarize yourself with the steps required to include the specific device(s) — these steps vary from device to device. If a device has already been included into a Z-Wave network, it must be excluded from that network first before it can be included in a new one (reference the device's manual for how to default it if exclusion isn't possible).

1. Tap the + icon in the top right corner of the screen, then tap Inclusion.
2. Perform the required steps at the device to include it into the new network.
3. The AEZW will recognize the device and confirm it has been included — click OK.
4. Repeat for additional Z-Wave devices.

Devices are automatically assigned a class type based on data provided during inclusion. Each device must also be assigned an "Entity," which maps it to the correct item within its assigned type. For more information, refer to the Z-Wave section of the E27 Knowledge Center.

FCC / IC Compliance

This device complies with Part 15 of the FCC Rules and ISEC RSS-102 radiation exposure limits for an uncontrolled environment. This transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located with any other antenna or transmitter except those approved for co-location. Contains FCC ID: UTH-ZW1512 (ELK-AEWF E27 Wi-Fi Adapter).

Warranty

The ELK-AEZW Z-Wave Module is warranted to be free from defects in materials and workmanship for a period of 2 years from date of manufacture. Elk makes no warranty regarding batteries used with wireless devices. Refer to Elk's website for the full warranty statement.

ELK Products, Inc. — PO Box 100, Hildebran, NC 28637 — 828-397-4200 — www.elkproducts.com