AutoSlide Wireless Push Button (AS05PBT) — Installation Instructions

Installation and pairing instructions for the AutoSlide Wireless Push Button — the default trigger controller for AutoSlide automatic door units.

Overview

The AutoSlide Wireless Push Button is the default controller for the AutoSlide automatic door unit, offering straightforward setup and reliable triggering. Each push button requires 4x CR2016 batteries (included) or 2x CR2032 batteries (one per clip), and includes a tape strip fixed to the back for mounting.

Note: the AutoSlide unit should already be mounted, powered on, and programmed before pairing the push button. Do not mount the push button until it has been successfully paired.

Quick Installation / Pairing

1. Remove the plastic battery-protector tab from the push button. Press the button to confirm it's working — a blue light should flash on the front.
2. Press the "Sensor Learn" button on the front of the AutoSlide unit's control panel — a red light should come on next to it.
3. Press the push button once so the blue light flashes. The red Sensor Learn light should flash three times.
4. Repeat step 3. The red light should now go out.
5. Press the push button — the AutoSlide unit should open the door. If it doesn't, see "Changing Sensor Port Channel" below.

Repeat this process for each additional push button. If the red Sensor Learn light goes out on step 3 instead of flashing, the push button is already paired to the unit.

Changing Sensor Port Channel

If a push button is paired but doesn't open the door, it may be set to a disabled sensor port. Identify the current channel by watching the Sensor Port buttons on the unit's control panel (labeled "Inside Sensor," "Outside Sensor," and "Pet Sensor") — the port that flashes green when the push button is pressed shows the channel it's assigned to.

To change the channel: loosen the screw at the bottom of the push button to remove its cover (take care not to fully remove the screw or lose the securing nut). Locate the small black switch on the push button's board and set it:

Once set, reassemble the push button and press it to confirm the door opens successfully.

Changing Batteries

Each push button accepts 4x CR2016 batteries (battery life depends on usage). If the button's range decreases or the blue light weakens, replace the batteries.

1. Loosen the screw at the bottom of the push button to remove the cover — take care not to fully remove the screw or lose the securing nut.
2. Use a screwdriver to gently but firmly pry the board out of the case, prying at the ends rather than the sides if possible.
3. Slide out the two black battery clips containing the batteries and replace them. Either 2x CR2016 or 1x CR2032 can go in each clip.
4. Push the board back into the housing and reassemble the cover and screw.

For a video walkthrough, see the AutoSlide USA Tech Help YouTube channel, or visit autoslide.com / call 833-337-5433.