X10 Duplex Wall Receptacle (Both Outlets Controlled)

Remotely Control Two Plug-In Appliances

When you plug an appliance into the X10 Duplex Receptacle Module (Both Outlets Controlled), you can turn it on/off remotely with an X10 controller. This heavy-duty receptacle supports two plug-in appliances up to 20A each. You can also automate an external load or downline receptacle by wiring it to the module's Blue Switched Leg Wire.

• Both outlets respond to on/off X10 commands
• Supports two plug-in appliances
• Installs in a single-gang box

When an appliance is plugged into the X10 Duplex Receptacle Module, you can still turn it on/off with its local switch. The module senses if any load is plugged into it, so when the switch is local toggled, the modules knows to respond.

Contents

• X10 Duplex Receptacle
• Mounting Hardware

NOTE: Wallplate not included.

The X10 Duplex Receptacle Module is an X10 Wired-In Receiver

A basic X10 system includes a Transmitter and a Receiver – both sold separately. Transmitters are control devices that send X10 signals through your home's electrical wiring to X10 Receivers. When a Receiver receives a command, it responds by turning a light, appliance or other electrical device On or Off, and sometimes Dim or Bright.

X10 Makes It So Easy To Automate Your Home!

X10 began manufacturing home automation and security products in the late 70s, establishing X10 as a smart home standard. X10 utilizes powerline technology to transmit control signals anywhere in your house over your existing electrical lines, so you can control lights and appliances throughout your home without running new wires! Have complete, automated control over lights and appliances from anywhere in your home with X10.

• Number of Controlled Outlets: 2
• Minimum Load: 40W
• Maximum Current: 20 Amps
• Operating Voltage: 110-120 VAC
• Dimensions: 2-3/4(H) x 1-3/4(W) x 1-1/2(D) inches (4-1/8 inch height including mounting tabs)
• Warranty: 2 Years Limited

»X10 XPR-W Duplex Wall Receptacle Installation Manual (.pdf)