Tripp Lite 1U UPS System with IP / RS232, 6 Outlet
TPHTR071U

The AVR Series Line-Interactive 1U Rack/Tower UPS System protects connected equipment from blackouts, brownouts, surges and...

Price: $599.95

• TPHTR071U AVR Series UPS System
  
• Mounting hardware
  
• USB and DB9 cabling
  
• PowerAlert Software
  
• Instruction manual

• TPHTR071U AVR Series line-interactive UPS offers battery-derived sine wave AC output during power outages, voltage regulation during brownouts and overvoltages, plus network-grade AC surge suppression
  
• 750VA/450W power handling capability compatibile with micro display devices, projectors, PVRs/DVRs, media center PCs, music servers and other sensitive electronic devices
  
• Maintains regulated 120V nominal output during brownouts as low as 83V and overvoltages as high as 147V
  
• Large internal batteries offer 24 min. runtime at half load (375VA/225W) and 7 min. runtime at full load (750VA/450W)
  
• Network-grade AC surge suppression protects sensitive A/V components from damage due to transient surges and improves componment performance (fuller audio/sharper video) by filtering disruptive EFI/RMI line noise
  
• Includes 6 UPS-supported outlets with two single-outlet load banks that can be powered on and off via software interface
  
• PowerAlert UPS monitoring and unattended shutdown software enables configurable network broadcast messaging, pager and email notification, event logging and running user-defined script commands
  
• Offers simultaneous monitoring by up to 3 directly connected devices through included USB, DB9, or the monitoring of any number of additional UPS systems over IP with included PowerAlert monitoring software
  
• Communication ports support messaging of UPS and line power status, including on-battery, low-battery, power restored, AC line voltage, DC battery voltage and remaining battery capacity
  
• Supports Tripp Lite's WatchDog software application to restore unresponsive programs by systematically restarting applications, operating systems and ultimately rebooting completely locked computers by momentarily switching UPS power off and back on again (requires optional WATCHDOGSW)
  
• Multi-function audible alarms and set of 5 front panel LEDs
  
• Supports 1U rackmount and upright tower installation
  
• UPS battery set ships fully assembled and ready for installation; no time-consuming connection of internal batteries by user is necessary
  
• Attractive all-black color scheme

• Voltage compatibility: 120 VAC
  
• Frequency compatibility: 60 Hz
  
• Output:
  - Output volt amp capacity (VA): 750
  - Output watt capacity (watts): 450
  - Output nominal voltage: 120VAC sine wave output in AC and battery mode
  - Output voltage regulation: LINE MODE: Sine wave line voltage 120V (-21% +8%), BATTERY MODE: Sine wave output within 5% of 120VAC
  - Output frequency regulation: LINE MODE: Passes line frequency of 60Hz +/-10% BATTERY MODE: Inverter output regulated to 60Hz +/-0.5Hz
  - Outlet quantity / type: 6 x NEMA 5-15R
  - Customized load management receptacles: "2 single-outlet load banks that support automated load shedding and remote reboot on demand of locked network devices. Configurable via PowerAlert software to automatically switch off optional loads, like monitors, to increase available runtime for servers and other critical devices. "
  - Overload protection: 15A input breaker
  
• Input:
  - Maximum input amps: 7A
  - Input connection type: NEMA 5-15P
  - Input cord length: 10 ft., 14 gauge
  - Recommended electrical service: 15A 120V
  
• Battery:
  - Full load runtime: 7 min. (450 watts)
  - Half load runtime: 24 min. (225 watts)
  - DC system voltage: 24 VDC
  - Typical battery lifespan: 3-6 years, depending on usage
  - Battery recharge rate: 2-4 hours to 90%
  - Replacement Battery Cartridge: RBC64-1U
  
• Voltage Regulation:
  - Voltage regulation description: Line-interactive voltage regulation system corrects input voltages between 83 and 147 back to usable 120V nominal levels.
  - Overvoltage correction: Input voltages between 128V and 147V are reduced by 12%
  - Brownout correction: Input voltages between 83V and 107V are boosted by 14%
  
• LEDs Alarms and Switches:
  - Front panel LEDs: 5 front panel LEDs - Green POWER LED, 3 color BATTERY CHARGE LED, 3 color OUTPUT LOAD LEVEL LED, red BATTERY WARNING LED.
  - Alarms: 3-function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous short beeps) and low battery (continuous tone)
  - Switches: 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions
  
• Surge / Noise Suppression:
  - AC surge suppression: 480 joules
  - AC suppression response time: Instantaneous
  - EMI / RFI AC noise suppression: Yes
  
• Physical:
  - Unit Dimensions (HWD/in): 1.75 x 17.5 x 16.75
  - Unit Dimensions (HWD/cm): 4.45 x 44.5 x 42.5
  - Material of construction: Steel
  - Form factors supported: Supports 1U rackmount installation in 2- or 4-post racks; rackmount flanges are reconfigurable to support upright tower placement
  - Cooling method: Built-in cooling fan
  - Battery Access: Battery access door allows hot swap battery replacement without powering connected equipment off
  
• Environmental:
  - Operating Temperature: +32 to +104 degrees Fahrenheit; 0 to +40 degrees Celsius
  - Storage Temperature: +5 to +122 degrees Fahrenheit; -15 to +50 degrees Celsius
  - Relative Humidity: 0 to 95%, non-condensing
  - Line mode BTU/hr. (Max.): 39.2
  - Battery mode BTU/hr. (Max.): 133.0
  
• Communications:
  - Network monitoring port: 2 built-in monitoring ports, 1 USB and 1 DB9. Each supports on battery, low battery, power restored, AC line voltage, DC battery voltage, load percentage, battery charge current, battery capacity, internal UPS temperature and line frequency status messag
  - Software and cabling included: PowerAlert UPS monitoring software for network and stand-alone operating systems; ships with complete USB and DB9 cabling.
  - WatchDog compatibility: Compatible with Tripp Lite's Watchdog Software to restore operation to locked equipment through soft reboot of application / OS or hard power off/on reboot of connected equipment—ideal for unattended kiosk applications
  
• Line / Battery Transfer
  - Transfer time from line power to battery mode: 2-4 milliseconds
  - Low voltage transfer to battery power: 83V (resets to line power as line voltage increases to 87V or higher)
  - High voltage transfer to battery power: 147V (resets to line power as line voltage decreases to 143V or lower)
  
• Certifications: Tested to UL1778 (USA), Tested to CSA (Canada), Class A (emissions), NOM (Mexico)
  
• Special Features:
  - EPO port: EPO (Emergency Power Off) port and cable
  - TVSS grounding: Back panel grounding point with thumbscrew for dataline surge suppressors and other network accessories requiring a safe grounding point
  - Cold Start: Yes, inverter can be cold started to enable temporary AC output during a power failure
  - Appearance: Attractive all-black color scheme