|
|
|
PulseWorx UPB Three-Phase Repeater
PCTPR120
The TPR-120 is designed to deliver all the benefits of UPB to 120/208V 3 phase environments such
as...
Price: $601.25
|
|
 Product Description
|
PULSEWORX THREE PHASE REPEATER
ALSO COMPATIBLE WITH OTHER UPB BASED DEVICES
The TPR-120 is designed to deliver all the benefits of UPB to 120/208V 3 phase environments such as restaurants, apartment complexes, office buildings or across multiple electrical phases.
The TPR-120 Three-Phase Repeater is a small electronic device that enables communication between PulseWorx™ and other devices using the Universal Powerline Bus (UPB™) method of communication on a three-phase 120/208VAC Delta-Wye 60Hz power. The Three-Phase Repeater will now bridge the communication gap between phases within multi-dwelling units, apartments, condominiums and light commercial office and restaurant facilities. Initially UPB™ communication was designed to work on a single phase powerline; the signals will not directly jump across all three phases of a 120/208V electrical system. The TPR now transfers any UPB™ multi-packet generated on a single phase and positions and repeats them properly onto all three phases of the powerline.
The TPR is simple to install and configure, just connect it to a standard 3-phase circuit breaker. The TPR is easily added to any UPB Network using UPStart Setup Software, which enables customization of the TPR's performance and the ability to run communication tests from the TPR to all devices in the network.
The TPR Three Phase Repeater is designed to be an integral part of PCS's PulseWorx™ Lighting Control System and it is also compatible with other UPB based devices.
PULSEWORX LIGHTING CONTROL SYSTEM
The UPB Wall Switch Dimmer is designed to be an integral part of a complete PulseWorx Lighting Control System. Like all PulseWorx devices, this device uses the patented UPB™ powerline communication technology (invented by PCS) to reliably communicate with any other UPB-compatible device(s) over the existing house electrical wires. No new wires are necessary making PulseWorx perfect for retrofit situations. When initial configuration is complete, a single push of a button is all you need to activate any group of lights (or virtually anything else that connects to AC power wiring) throughout the house simultaneously.
|
Specifications
|
|
Pulseworx Three-Phase Repeater Spec Sheet (.pdf)
Pulseworx Three-Phase Repeater Owner's Guide (.pdf)
Features:
- Improved Communication - Automatic repetition of all multi-packet messaging transmissions across three-phase network
- Adjustable Receive Sensitivity - If powerline noise is severe the sensitivity can be adjusted from LOW to HIGH to enable the TPR to filter out most noise to ensure proper communication
- Simple Installation - Installs in standard 3-gang junction box or suitable enclosure near main electrical panel
- Feedback - Blue/red status LED for each phase of the powerline
- Perfect For Retrofit - Transmits signals over existing power wiring so there is no need for expensive hard wiring.
- UPStart Configurable - Use UPStart to add TPR to the network, perform communication tests, print reports, and adjust sensitivity
|
|
|
|
|
|
|
|
Why Automate
